Removing Concrete Floor Anchors

Therefore don t be too hard on the anchor bolt when it refuses to budge.

Removing concrete floor anchors.

It s just doing its job. The boys from pennoscan removing one of 1500 masonry anchors from a warehouse floor. Using a cutoff saw or grinding wheel cut the wedge anchor off at the surface of the concrete. A steel anchor is stubborn and its removal will usually cause damage to the concrete floor.

Place the threaded nut onto the concrete anchor bolt. Step 2 grip with pliers then grip the nut with pliers and pull upward. If needed a hammer can be used to knock the anchoring tube below the floor and in some cases these tubes can simply be pulled out of the hole entirely. Make sure it s tight and flush with the bolt s upper side.

The role of concrete anchor bolts consists of creating a permanent or at the very least semi permanent bond between the structure and concrete component. If the anchors are of the screw in type place a screwdriver bit into the drill position the bit into the head of the anchor and turn the fastener loose in a counterclockwise direction. Step 3 use a bolt extractor on a stubborn bolt. If the bolt is rusted in place spray it with a penetrating lubricant and allow the lubricant to soak in according to manufacturer s instructions before removing.

This video shows the process for removing the old unusable bolts and replacing them with new wedge anchor bolts in preparation for receiving a new delphi spe. Often a bolt can be removed simply by unscrewing it. Tapcons are removable because they are threaded screws that tap threads into the concrete brick or block. Usually a screwdriver pipe wrench or vise grips can unthread the protruding bolt leaving the female anchor flush with the concrete.

Any protruding metal may be pounded into the concrete using a heavy hammer. Female concrete anchors are generally simpler to remove. Some concrete anchors such as the tapcon concrete screws can be removed easily by turning them counterclockwise. Protruding anchors may be removed using and angle grinder of a boltbreaker.

Remove the anchor bolt from the concrete by turning the bolt counterclockwise with the socket. To be removed wedge anchors can be sawed off with a hacksaw or cutoff wheel at the surface of the base material.