Replace Damaged Vinyl Siding Panel

When replacing siding try to purchase a piece from the same manufacturer in the same color.

Replace damaged vinyl siding panel.

Save big with vinyl siding. Pry the nails out of the nail hem of the damaged panel. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Remove the nails on the lap board then use the claw of the hammer to split the board down the center image 1.

Score down the damaged lap siding with a utility knife. Cut a replacement panel that is 4 inches longer than the damaged section. Use a flat pry bar to remove the nails and the damaged section of siding. L x 13 13 in.

It is commonly used for accent walls or to complement any type of siding. The novikstone ds panel is 41 5 in. Cut piece of faded siding from an inconspicuous spot to replace the damaged section. 15 minute vinyl siding repair with a zip tool starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.

Apply caulk apply generous beads of butyl or gutter caulk on the adjacent siding about 1 2 inch from the edges of the cutout area. Slip the siding removal tool behind the bottom edge of the panel located above the one that needs replacing. Vinyl siding is designed to withstand weather and resist moisture damage. Remove the nails in the corner cap.

Use framing square and utility knife to cut through face of siding. Slide the tool along the edge of the upper siding panel and unzip the locking mechanism on the damaged panel. Pull the nails holding the damaged siding and remove the damaged piece. Cut a large rectangle out of the damaged panel.

It can have the look of wood siding without the ongoing work and expense. Work your hand into a seam between pieces then release the siding from the nailing strip. Push up on the panel to unlock it and then pull down to remove the damaged panel. It ll better match the house than brand new siding.

Once all the nails are removed from the adjoining board the damaged one should just pull out. The vinyl siding zip tool will save you loads of time. Cut or chisel through the sides of the panel and remove the lower half.